Engineer IV (WMBJP00002535) Houston, TX

Engineer IV (WMBJP00002535) Houston, TX

 If you post this job on a job board, please do not use company name or salary.
 Experience level: Mid-senior Experience required: 7 Years Education level: All education level Job function: Engineering Industry: Oil & Energy Pay rate : View hourly payrate Total position: 1 Relocation assistance: No Visa sponsorship eligibility: No
Support
Provide Tier IV Level support and provide aid to any issue that may occur in your area or on the projects you’re working on.

Engineering & Design
Read, interpret, review, and redline P&IDs, Electrical and Instrumentation Schematics.
Participate in design review of all projects.
Led a automation (controls) focused PHA
Take complete ownership of Tagging, Symbols and References for all projects
Key equipment design parameters – design/ operating pressure; design/ operating temperature.
Hardware selection of key hardware components
Instrumentation– suitability for the selected parameters; ranges; alarm set points; trip set points
Control panel interfaces – signals to/ from main control room and field instruments; hardwired signals; serial linked signals
Control loops between the instruments and equipment
Ensure project requirements, expectations, or operational points are within WIMS operating philosophies & standards
Author and ensure consistency between documents such as instrument index, control philosophy, programs, and C&E.
Review of P&ID to check consistency with ESD philosophy
PLC Programming
• Write Logic for SCP and ESD PLC
• Write logic all transmitters and devices
• Write Logic for all compressors
• Write Logic for Scada Packs
• Write Logic generators
• Write Logic for Vent Fans
• Write Logic for Gas Coolers
• Write Logic for Gas Control
• Write Logic for Power monitor
• Write Logic for air compressors
• Write Logic for ESD
• Write Logic for Fire and Gas Detectors
• Setup all devices and input IP addresses
• Order and Procure Modules and devices for project
• Request IP address allocations from IT
• Gas Control Data Test, Point to Point and final data review.
HMI Automation
• Create Screen and alarms for SCP and ESD PLC
• Create Screen and alarms all transmitters and devices
• Create Screen and alarms for all compressors
• Create Screen and alarms for Scada Packs
• Create Screen and alarms generators
• Create Screen and alarms for Vent Fans
• Create Screen and alarms for Gas Coolers
• Create Screen and alarms for Station Control
• Create Screen and alarms Daily Report
• Create Screen and alarms for trending
• Create Screens alarms for ESD , Fire and Gas
• Order HMI Machine for Wonderware
• Order Wonderware License

Fat Testing
• Travel and Conduct Factory acceptance test of Control buildings
• Travel and Conduct Factory acceptance test of Control Panels
• Travel and Conduct Factory acceptance test of Motor Control Centers
Documents
Maintain, test, verify, cause and effect, and IO list.

Commissioning
• Travel and commission the entire station controls and automation system.
• Test and commission every device tied into the control system as mentioned in PLC Programming and HMI Automation.
• Test and commission Scada

Experience:
• 8-10 years of experience preferred
• 5 years of experience is minimum
• Prior oil and gas experience